PUMPS
SLIDING VANE PUMP
- Ideal for thin & viscous liquids
- Highly efficient at low flow & on thick liquids
- Excellent suction-lift & line-stripping capabilities
- Self-adjusting vanes
- Dry-run capabilities
Typical products handled:
- Hydrocarbons (fuel, gasoil, heavy oil etc.)
- Greases & lube oils, waste oils
- Crude oil (depending on particle content)
- Asphalt
- Bitumen
- Solvents
- LPG
SCREW PUMP
- Highest flow rate achievable by a rotary PD pump
- High tolerance for entrained air & other gases
- Low internal velocities, minimal shear
- Relatively low NPSH requirement
- Relatively low-pulsation flow
- Non-contacting screws (if using timing gear)
Typical products handled:
- Hydrocarbons (fuel, gasoil, heavy oils etc.)
- Greases & lube oils, waste oils
- Crude oils (depending on particle content)
INTERNAL GEAR PUMPS
- Self-priming & dry-run capabilities
- Volumetrically consistent performance over time without any
adjustment
- Regular & constant output, independent of change in
pressure of fluid viscosity
Typical products handled:
- Hydrocarbons (fuel, gasoil, heavy oils etc.)
- Asphalt
- Bitumen
- Emulsions
- Thermal fluids
CENTRIFUGAL PUMP
- Suitable foe thin to very high viscosities
- Precise, consistent flow rates
- Metal-to-metal gears
- Multi-purpose design
- Seal-less (eliminates leaks) or sealed design options
- Enviro-friendly
Typical products handled:
- Hydrocarbons (fuel, gasoil, heavy oils etc.)
- Fluids with heavy residues
- Chemicals
- Pharmaceuticals
- Paints, coatings & adhesives
- Pulp & paper
CENTRIFUGAL PUMP
- Heavy-duty shaft, bearings, seals & housing
- Constant pressure & flow rate
- Wide best efficiency point (BEP) window
- Low vibration with high radial loads
- Solid shaft resists deflection
- Meet ASME/ANSI specifications and dimensions
Typical products handled:
- General chemical
- Acids
- Solvents
REGENERATIVE TURBINE PUMP
- Quiet, vibration-free operation
- Low maintenance, single-stage impeller
- Simple installation with C-face close-coupled mounting
- Versatile 3-port arrangement, self-venting design
- Balanced mechanical seal, unique cartridge design for simplicity
of assembly / maintenance
Typical products handled:
- LPG Autogas dispensers, single or two hoses
- Propane
- Butane
- Dimethyl Ether (DME)
- CO²
- Refrigerants
- Anhydrous ammonia
- Boiler feed